Sony Xplod Amplifier Wiring color code

Problem with Sony Xplod XM-554ZR Car Audio Amplifier

Wiring

Would like to know the wiring color code

need help my cdx-gt71w will not take a cd and will not flip down enough to put one in

Would like to know the wiring color code of what exactly?

Any update on your Sony CDX-GT71W wiring?

POWER ISSUUE :Sony Xplod XM-554ZR Car Audio Amplifier

Problem with Sony Xplod XM-554ZR Car Audio Amplifier

Quick question about the power

I have the 12volt live wire connected to the car battery, and a remote wire connected to the aux power supply..... The amp works and everything is fine. My question is, when the car is off, the power light (green) is still on. IS IT SUPPOSED TO BE???...the reason why I ask is because, me being a moron, spliced the live 12v wire from the battery to both terminals (REM & 12v), of course the amp worked fine, but overnight it completely drained the battery ( had to get a new battery), I don't want the same thing to happen again.


The remote turn on terminal on the amp needs to be connected to a switched power source. Typically, it's the remote turn-on/power antenna wire on the head unit. If your head unit doesn't have such a control wire, connect the remote turn-on terminal to a wire that's controlled by the ignition switch. 

It's VERY important to fuse all of the wires properly. If you're unsure of the proper fuse for a given wire size, read pages 14 and 16 of the Basic Car Audio Electronics site. 


OR
No you will need your separate remote wire connected to either the back on you deck or to a source that completely cuts off with the car. Your battery is always powered you amp needs a cut off source to tell it to turn off when the car is off.

SONY Amp wont kick on

Problem with Sony Xplod XM-554ZR Car Audio Amplifier

Amp wont kick on

I have the power to + and grounded, i don't have remote tho do i need that, and i only have one fuse on the actual amp there's 2 slots for fuses tho but my cousin said i only need on and that's the one on the side closet to power and ground.

You have to install the remote wire or it will not work. I'd put in the other fuse as well just in case you have the fuse in the wrong slot or it needs both fuses.

OR

The amp will not turn on until it receives 12v via the remote turn on. Also, if your amp has two fuse slots, I would make sure they were both filled with the appropriate fuses.

SONY Xplode 52WX4 CD player manual.

Problem with Sony Xplod XM-554ZR Car Audio Amplifier

SONY Xplode 52WX4 CD player - no manual.

We can set the radio presets but can't figure out how to set the time - any ideas? Any place to download a manual?

Go to sony.com and go to support enter your model #.

set/adjust the clock for Sony Xplod XM-554ZR Car Audio Amplifier

Problem with Sony Xplod XM-554ZR Car Audio Amplifier

How do i set/adjust the clock for my Sony Xplod car stereo?

100dB+
changer control CDX-GT31W
Drives - s

Http://audio.manualsonline.com/manuals/mfg/sony/cdxgt310_cdxgt31w_1.html
click on get manual......the clock set instructions are on page 5

set FM channels on Sony Xplod XM-554ZR Car Audio Amplifier

Problem with Sony Xplod XM-554ZR Car Audio Amplifier
How to set FM channels in d system ,i hav a sony xplod cassette stereo...plzzz help

GO TO 

Http://www.xplodsony.com/support for info on all sony items

Sony Xplod XM-554ZR Car Audio Amplifier Installation

Problem with Sony Xplod XM-554ZR Car Audio Amplifier

How do i intall my amp?

I have a xplode 600w amp how do i install it to my speakers and cd player step by step

First you need to run a power cable for the battery to where ever you are going to place the amp DO NOT hook the cable to the battery until the very last just wire it to the amp for now.next you will want to ground your amp hook the ground wire to the amp and the other end to a solid piece of metal in the car this is very important if you don't get good metal on metal contact you'll blow a fuse. If you can hide it well strip back a bit of carpeting and use sand paper to remove all paint from the metal and drill a hole for a screw. once that is finished you will need to run a remote wire from the amp to the car stereo usually these are the blue wire on the harness in the dash. once that is hooked up run the rca cables (reds and whites) plug in to amp and then in to back of cd player. once this is all hooked up and fully secure hook the power cable to the battery make good contact and if everything is grounded right you should get the lights on in the amp. Next step hook up the speakers run speaker wire from the amp to your speakers make sure negative goes to negative and positive to positive .

Sony Xplod XM-554ZR Car Audio Amplifier Wiring problem

Problem with Sony Xplod XM-554ZR Car Audio Amplifier

Wiring problem

The power wires details for  sony xplod head unit model is cdx-gt260

Power wires are as follows -

Red = Switched power (ACC)

Yellow = Constant power

Black = Ground

Sony Xplod-XM-554ZR Amplifier circuit board resistor

Problem with Sony Xplod XM-554ZR Car Audio Amplifier

Sony Xplod-XM-554ZR-- - - Resistor on circuit board HELP!!!

Well my brothers amp on his car just quit working. Me being an EE student i go ahead and open up to see whats inside. Unscrew everything and turn the board over to find a "open" surface mount resistor. I would like to find out what the value is for this "R466" (around in the middle of the board). This resistor burnt up, so basically it is unidentifiable. Possible values but not sure could be 2R1 which is 2.1 Ohms or, could be 221 which equals 220 Ohms. Can anyone please tell me the value or numbers on the top of this resistor, i would greatly appreaciate it. AGAIN the resistor is R466 around the middle of the board.

R466 is chip resistor 220 Ohms 1/8 watt connecting between Emitter pins of Q408 and Q409.

Its part number is ...

R466 "1-216-182-00" RES-CHIP 220 5% 1/8W

Available in Part Store.

Sony Xplod amp will not get off of power protection mode

Problem with Sony Xplod XM-554ZR Car Audio Amplifier

Xplod amp will not get off of power protection mode

Yesterday my Sony xplod 600w xm554ZR amplifiers power protection light had come on and it wont work now. I have checked all of the fuses and they are in mint condition, the amplifier was not even warm. I had disconnected all of my wiring and re connected it all, but none of this has seemed to work. Any ideas for a solution for this problem please let me know.

If the protect light stays on the amp is blown or has flawed components and is only repairable by expirenced sony tech

1000 watt sony XPLOD amp LED turns RED

Problem with Sony Xplod XM-554ZR Car Audio Amplifier

I have 1000 watt sony XPLOD amp and i just

I have 1000 watt sony XPLOD amp and i just installed it today. with new monster cable&ground. the green light turns on& thumping goes for a little. i try to raise up just a little bit& after 2 thumps my amp light turns red.. whats happening??

===========

I think if I'm correct you are running to many speakers and have your ohm load to low for the amp causing it to go into protection. 1 single voice coil speaker equals 4 ohms for every speaker you have divide 4 ohms by number of speakers (ie. 2 single voice coil speakers equals 2 ohms or 1 dual voice coil speaker equals 2 ohms) this is for parallel wiring. For series wiring do the opposite if you have 2 speakers you are running an ohm load of 8 ohms the same for a dual voice coil ran in series. Series is positive on the amp to positive on hook up A negative of hook up A to positive of hook up B negative of hook up B to negative on the amp.

OR

It isn't getting enough power and its tripping the internal switch on the amp and putting it in safe mode. either your wire isn't a high enough gauge. you might need a capacitor or you need bigger wire.

Sony Car Audio Amplifier fuse blows

Problem with Sony Xplod XM-554ZR Car Audio Amplifier

25 Amp fuses blow, after the unit got wet.

The unit is dry but a continuity check at the fuse socket shows a short circuit.

The problem is related to 

LOOSE GROUND or INSECURE GROUND..for the amp.

Put 2 subs on a Sony XM 554ZR bridged

Problem with Sony Xplod XM-554ZR Car Audio Amplifier

How to put 2 subs on a Sony XM 554ZR

How to put 2 subs on a Sony XM 554ZR bridged

======

Unless it is a 4 channel then you will have to run them in series. Keep in mind that you will only have mono sound.

sony xplod 500watt car amp Red light Reset Repair

Problem with Sony Xplod XM-554ZR Car Audio Amplifier

Free amp problems

I was given an sony xplod 500watt car amp but the red light is on for the out put. my question is is it worth it to repair it or just toss it.

As you are probably aware the red light would be the circuit protection.

If you are confident with electronics it could be worth repairing yourself as the component parts are reletively cheap but that depends on how you feel about fault finding and soldering or do you know someone who you could ask to take a look and possibly do the work for you.

It might be worth getting a quote before tossing it in the bin though.

Sony Xplod XM-554ZR Car Audio Amplifier going in to power protect mode

Problem with Sony Xplod XM-554ZR Car Audio Amplifier

Wont stop going in to power protect mode

I have a sony XM554ZR amplifier installed in my car. I have checked and double checked the wiring but still it will only go in to power protect mode. Any advice / suggestions are welcome.

I have an amp installed but can not get it to come out of power protect mode. All wiring and fuses have been checked. I have disconnected all RCA and speaker wires and put a multimeter accross the ground / power (14.4 result) and accross the ground / rem (14.25 result) Does this mean that the amp is blown or is there any thing else that I should try?

does it still do it with speaker disconnected?

iuf not then speakers are issue.otherwise amplifier needs to be replaced.

Sony Xplod Car Audio Amplifier sound cuts off then power led blinks

Problem with Sony Xplod XM-554ZR Car Audio Amplifier

My sounds cuts off and then my green power light

My sounds cuts off and then my green power light starts to blink

This sounds like you are having a problem with the ground wire. When the amp is not properly grounding the amp will loose power the light will flicker and your speakers will stop working. 

Make sure the ground wire for the amp (the black wire) is grounded correctly. The end of the wire or connector should be firmly grounded under a nut for example.

manual or any e-book for Sony Amplifier connection

Problem with Sony Xplod XM-554ZR Car Audio Amplifier


Hello everybody, i need a manual or any e-book that can help me to do a successful connection... 
Help!!!!!! Who can help me?? 



Look on Sony's website for a quick start or users guide.
Sony Documents

You will need your model number to find any information.
Good Luck!

Go to this web site www.retrevo.com for manual

sony xplode 100w amp bridged push a 1600w cab

Problem with Sony Xplod XM-554ZR Car Audio Amplifier

Will a sony xplode 100w amp bridged push a 1600w cab? if not what is the best compatible cabinet wattage reccomedation?


100watt amp and 1600 watt cab?? Your amp will run it but a lot of the dynnamics of the speakers won't be there.

How do I hook up a sub woofer

Problem with Sony Xplod XM-554ZR Car Audio Amplifier


How do I hook up a sub woofer to my Sony 52wx4 radio. I dont have a wiring diagram?




You can hook it up a couple of ways.

Depending on how many subs you have and what ohms they are running at here is the chart you need. If your going to run one sub off it the last option is the way to go. Your going to need to find out the power of your subs or else the power could be off and you could blow the sub. If the rms power is higher than 130watts per coil you will be fine. If so there are four channels on the amp and two should show a line going to each other that says bridge. Hook up the positives and the negative of the subs as shown on the amp that will get your max power. If your sub is running at 4 ohm. Let me know, if not thats how you would do it.

Also for the power and remote wires. Hook up a power wire (16 gauge would be plenty fine) from the battery to the + terminal of the amp. Then take an equal or bigger sized wire from the - side of the amp and secure it to any medal part of the body of the car. If there is paint on it get if off. (not on the outside of your car or where any water would be.) Then run a remote wire from your stereo (most the times it is blue and white) to the remote terminal of the amp. This tell the amp when to turn on and off. Your amp will not turn on with out all of these wires. Good luck to you and let me know how it works out.

4 x 55W RMS @ 4Ohm

4 x 65W RMS @ 2Ohm

1 x 130W RMS @ 4Ohm - Bridge

Sony Xplod XM-554ZR Car Audio Amplifier sound is very low

My car is a 92 ford falcon when u play bassie

My car is a 92 ford falcon when u play bassie music u can only just here it out side the car but when u pop the bot u can rarely here it what can i do to make it louder out side the car


Crack the windows and drop the sony system and get your self a nice mono block class d amp 1000 rms should be loud enough btw bild your stereo based on rms power not max power rms is the true power you got so like 2 500 watt rms 12s on a 1000 watt rms amp or just a 1000 watt woofer it will be jsut as loud as the 2 12s