Torque settings mains big ends head

 what are the torque settings for bearing mains,big ends and head cylinder bolts

BIG END, MAINS AND CYLINDER HEAD TORQUE SETTINGS FOR 2.4 LITRE JEEP CHEROKEE 2003 MODEL

1. Tighten the cylinder head bolts in the sequence shown. Using the 4 step torque turn method, tighten according to the following values:

• • Step 1: All to 34 Nm (25 ft. lbs.)
  • Step 2: All to 68 Nm (50 ft. lbs.)
  • Step 3: All to 68 Nm (50 ft. lbs.)

CAUTION: Do not use a torque wrench for the following step.
Step 4: Turn an additional 1/4 turn

• Step 5: Install and tighten bolts (1-10) in sequence shown, to 41 Nm (30 ft. lbs.) .

1. Tighten bolts (1-10) again to 41 Nm (30 ft. lbs.) PLUS 1/4 turn in sequence shown.
2. Install main bearing bedplate to engine block bolts (11-20), and torque each bolt to 28 Nm (20 ft. lbs.) in sequence shown.

Connecting Rod Cap Bolts 54 Nm (40 ft. lbs.) + 1/4 turn

1997 Jetta: Torque settings..vw..the head, fly wheel, big ends.

1997 Jetta3 1800 feul injection

Vibration Damper/belt Pulley Tighten 20 Nm (14.8 ft lb) Crankshaft Toothed Belt Sprocket Tighten 90 Nm (66 ft lb) + 90° Camshaft Sprocket Tighten 80 Nm (60 ft lb)

Main Bearing Cap

Tighten

65 Nm (48 ft lb)

FLYWHEEL TORQUE

Torque

60 Nm. (44 ft. lbs.) + 1/4 turn (90°) [1]

[1] Always replace bolts.

CYLINDER HEAD TIGHTENING TORQUE [1] :
1st sequence: 40 Nm (30 ft lb)
2nd sequence: 60 Nm (43 ft lb)
Final sequence: plus 1/2 turn (180°)

Here are some additional specifications, thanks

ntake Manifold

Mounting Bolts

25 Nm (18 ft. lbs.)

Bearing Cap Nut

20 Nm (15 ft. lbs.)

Rod Bearing Cap

Assembly Tighten 30 Nm (22 ft lb) + 90° To measure radial clearance Tighten 30 Nm (22 ft lb) but NOT additional 90°

TIGHTENING SPECIFICATIONS

Oil Pump Bolt	20 Nm (14 ft. lbs.)
Oil Tube To Block	10 Nm (7 ft. lbs.)

Exhaust Manifold to Cyl. Head	25 Nm (18 ft lb)
Exhaust Manifold to Front Exhaust Pipe	40 Nm (30 ft lb)

Water Pump

TIGHTENING SPECIFICATIONS Cover Bolts 10 Nm (7 ft. lbs.) Mounting Bolt and Studs 20 Nm (15 ft. lbs.) + 1/4 turn (90°) Pulley Bolts 25 Nm (18 ft. lbs.)

TIGHTENING SPECIFICATIONS 
Connecting Rod Nuts:
Tighten In Two Stages:

First Stage	30 Nm (22 ft. lbs.)
Second Stage	turn an additional 90°(1/4 turn)

NOTE:

• Oil threads and contact surfaces.
• Tighten only to: 30 Nm (22 ft. lbs.) when measuring radial (oil) clearance.