How to Build a Battery Isolator

How to Build a Battery Isolator

Automotive battery charging circuits are designed to recharge and maintain a single battery. However, automobiles with custom audio systems, electric winches or other high-drain devices may require a second battery to power these devices.


One of the problems with connecting two batteries directly to an automotive charging system is that if one battery is weaker (provides less electrical current at the same voltage) than the other, the charging system may be taxed beyond its design parameters for providing power. This also has the undesirable consequence of draining the “good” battery to equalize the charge in both batteries.


One way to charge both batteries without overtaxing the charging system is by using a battery isolator. A battery isolator is constructed using two diodes, which act as one-way electrical check valves for the charging system.



Things You'll Need
Solder-type lug terminals (3)
High-current diodes (two; RF1501TF3S or equivalent – See “Resources”)
Soldering iron
Electronic solder
Electrical wire (insulated copper, minimum 8 AWG thickness)
Electrical pliers
Permanent marker


Instructions
Cut three, 2-foot-long pieces of wire and strip one-half inch of insulation from each wire end.

Solder a lug terminal to one end of the first wire, and mark the side of the lug terminal with the letter “A.” Solder the free end of the first wire to the anode leads on both diodes.

Solder a lug terminal to one end of the second wire, and mark the side of the lug terminal with the number “1.” Solder the free end of this wire to the cathode lead on the first diode.

Solder a lug terminal to one end of the third wire, and mark the side of the lug terminal with the number “2.” Solder the free end of this wire to the cathode lead on the second diode.