solutionsforeverything

Code p1135 what wrong help,toyota 2000,highlander 2000 toyota highlander 6 cylinder,code p1135 That code is specific to the Air-Fuel Ratio (A/F) Sensor Heater Circuit Malfunction (Bank 1 Sensor 1) P1135 Trouble Area: Open or short in A/F sensor (bank 1, sensor 1) A/F sensor (bank 1, sensor 1) heater ECM.

Getting code p1135 and p1155 on toyota rav4 2002 Here's what the codes mean: P1135 Air/Fuel Sensor Heater Circuit Response (Bank 1 Sensor 1) P1155 Air/Fuel Sensor Heater Circuit. (Bank 1 Sensor 2 This is mainly related to the oxygen sensors. It maybe the sensors themselves or an open wire going to te sensors. They are mainly located on the exhaust pipe. One before and on after the catalytic converter. Try the bottom two my bottom 2 went as well. The sensors on top are referred to as air/fuel sensors or "wide band" sensors. The sensors on the bottom (after the cat) are O2 sensors. Bank 1 is the pipe that comes from cylinder #1 and bank 2 is the pipe that incorporates cylinder #2.

How to find timing belts marks toyota rav4 2l Can not find proper timing marks to set timing belt on toyota rav4 2 liter. I have just replaced my water pump on my 1998 RAVE4, also, the timing belt and the other two belts. I had a tough time with the timing marks. The way you line these marks up is easy if you take the time, First, if you are changing the timing belt you pull the balancer and both top and bottom plastic covers,(do not try to pull top cover off before you take off balencer and the motor mount off or you will just break it.), Second after covers are removed you will have access to the timing belt, you can now remove it by loosening the tensioner bolt and pushing down on the tensioner wheel, the belt then can be taken off. Third take out number one sparkplug and replace the bottom cover by maybe two bolts so that you can see marks on cover, next replace the balancer and bolt. Turn the motor over by hand with the balancer so the small divit on the back of the balan...

2003 toyota rav 4 dash lights blink till u turn on headlights Dash board lights flash when you start and stay on for three minutes or to you turn on head lights. It seems your car has got round problem,check all and repair where necessary

Blinking light on dash board I have a arrow blinking on my dash board. It does'nt blink all the time but when it does, the car seem to start out in 4th or 5th gear. I have a 1999 volvo s70 It may be possible that your Park Neutral Position Switch (PNP Switch) is getting ready to fail. The switch is located right on top of your transmission and is connected to your shifter. This is a common problem. I doubt that your entire transmission is failing, because that is rare with the S70 line. Has your check engine light come on? The check engine light can be triggered by the failing PNP switch. You should take the car to a autozone if you do not have a code reader to see if this problem is sending a code to the computer. If you are unsure where the port is for the code reader, it is located inside of the center console armrest and has OBD II on it. It will same something such as Transmission position switch failure....if I can remember correctly when it happened to me. If i...

2001 Volvo V40 arrow warning light Turning on car, shifted hard into drive, then drove fine. However, the arrow auto transmission indicator on the dash is flashing. Most likely the transmission range switch is failing.  Have someone check the transmission computer for codes.

Arrow flashing on a s90 volvo dash board Engine/transmission fault. You can disconnect the battery for 5 minutes to clear the computer if it returns you have a problem.